Brazing cast iron - Moparts Forums

Register Log In Moparts Forums Unlawfl's Race & Engine Tech Brazing cast iron

Print Thread

Brazing cast iron #1935129 10/19/15 08:21 PM 10/19/15 08:21 PM
Joined: Sep 2014 Posts: 181 Maryland T twayne24365 OP member
twayne24365 OP member T Joined: Sep 2014 Posts: 181 Maryland	I have a set of fully ported 452 heads and they were epoxied on the side of the ports. One of the pieces of epoxy was loose so I carefully ground it off. Would it be better to braze these shut or re epoxy them?

Entire Thread
Subject	Posted By	Posted
Brazing cast iron	twayne24365	10/20/15 12:21 AM
Re: Brazing cast iron	Iowan	10/20/15 12:26 AM
Re: Brazing cast iron	DemonDust	10/20/15 12:58 AM
Re: Brazing cast iron	dvw	10/20/15 01:12 AM
Re: Brazing cast iron	DemonDust	10/20/15 01:33 AM
Re: Brazing cast iron	twayne24365	10/20/15 01:50 AM
Re: Brazing cast iron	DemonDust	10/20/15 01:55 AM
Re: Brazing cast iron	DemonDust	10/20/15 01:57 AM
Re: Brazing cast iron	twayne24365	10/20/15 01:57 AM
Re: Brazing cast iron	DemonDust	10/20/15 02:01 AM
Re: Brazing cast iron	twayne24365	10/20/15 02:04 AM
Re: Brazing cast iron	DemonDust	10/20/15 02:05 AM
Re: Brazing cast iron	twayne24365	10/20/15 02:11 AM
Re: Brazing cast iron	Azzkikrcuda	10/20/15 02:30 AM
Re: Brazing cast iron	BIG DRAG	10/20/15 02:28 AM
Re: Brazing cast iron	Stanton	10/20/15 03:43 AM

Moderated by Al_Alguire, Hotwheelsjr, moparts, not_a_charger, RangerDan440, tboomer

Hop To

Powered by UBB.threads™ PHP Forum Software 7.7.1