Unless this is a big error on the QC dept it might be the uppers vs the lowers. I got to wondering and these are Mclevite and King brands and the uppers are slightly different then the lowers and I myself do assembly in stages and you can pretty much eyeball if you have a upper and lower in the wrong spot.

Yes I have missed it one time and knew right away as it creates a tight spot and you surpass your breakaway tq at that point so if its just two rods I had to go back and look at.

But in this day and age id not be surprised if some got mis stamped.

But it does look like Dragons are a bit off. Might be an easy fix if they are not too far off or id send the company a pic and ask for some correct bearing since you paid for them.