Problem re-attaching steering coupler to shaft

Print Thread

Problem re-attaching steering coupler to shaft #176556 12/27/08 07:56 PM 12/27/08 07:56 PM
Joined: Oct 2004 Posts: 1,074 So Cal, USA Fab64 OP super stock
Fab64 OP super stock Joined: Oct 2004 Posts: 1,074 So Cal, USA	Hi all, I've been trying to re-install my steering coupler to the steering shaft, and am having trouble getting it to slide on. There's still about 1/2" to go before I can insert the rolled pin. The FSM doesn't say anything about needing a special tool to do this, but it does say to "align the master spline". I didn't notice any difference in any of the splines when I attached it. Is it even possible to get it onto the shaft if it's not aligned correctly? Any suggestions would be much appreciated - thanks! Roger Last edited by Fab64; 12/27/08 08:02 PM.

Entire Thread
Subject	Posted By	Posted
Problem re-attaching steering coupler to shaft	Fab64	12/27/08 11:56 PM
Re: Problem re-attaching steering coupler to shaft	Anonymous	12/28/08 12:18 AM
Re: Problem re-attaching steering coupler to shaft	mopargem	12/28/08 12:35 AM
Re: Problem re-attaching steering coupler to shaft	Fab64	12/28/08 01:13 AM
Re: Problem re-attaching steering coupler to shaft	CYACOP	12/28/08 01:43 AM
Re: Problem re-attaching steering coupler to shaft	Snoopy	12/28/08 03:22 PM
Re: Problem re-attaching steering coupler to shaft	Snoopy	12/28/08 03:22 PM

Hop To