Stock360 bottom end build

Print Thread

Re: Stock360 bottom end build [Re: qwkmopardan] #1713910 12/22/14 09:18 PM 12/22/14 09:18 PM
Joined: Mar 2006 Posts: 9,865 MI, usa dvw master
dvw master Joined: Mar 2006 Posts: 9,865 MI, usa	Quote: Quote: Ok so .060 off the face where would that put me at compression wise? Just curious on how much it'll bump it. Also planning on running shim head gaskets Cutting .06 off heads will reduce comb. chamber by aprox 10cc. The comp. Ratio would go from 7.8/1 CR to 8.5/1 CR. Not worth the expense. Pistons .01 in the hole would get you 9.6/1 CR without carving on the heads. A very valid point. Either put pistons in it or run as is. Just make a correct cam choice to match the compression. Doug

Hop To