Quote:

Quote:

sure does look like DA grinder marks where the vin once was ??




Yep usually they only go from top left to bottom right all the way across the VIN pad and no machine marks go from top right to bottom left like in the middle of that VIN pad IMO too



I've seen pads with distinct mill marks and some that aren't visable at all. To say "they go from top left to bottom right" imo is misleading It depends on where the mill operator starts his cut, mill speed, cutter depth and it's condition.

IMO, on trying to decide if a pad has been tampered with, it's the size of the mill marks. They give an idea of the cutter diameter that Chrysler used..
I've personally seen them all over the place