Alright, got some plates in where the mounts will be, firewall is cut, so now I got all kinds of room. Question I got now is how high should I mount the engine, I don't have a bellhousing yet, so I can't quite figure out the drivetrain angles. Heres some pics, first is some mounts I made, 3/8" plate with DOM tubing and bushings, planning on mounting them to the flat plate I had to weld seen in the 2nd photo. Last one, if I can ppost them all, shows where I have it set, too low, the mounts would be higher than the stock ones I plan to connect to. Hope you can understand my plan.