Quote:

---

Right now oil is draining, filter pulled, new plugs installed and carb is off.
Not sure what to look for or where to start.

---

Change oil/filter/clean or replace plugs. remove & invert the bowls & set the "dry" float level which'll be from the top of the float(s) to the inside bowl surface using a drill bit to measure. Since you're inverting it you'll be measureing from the bottom of the float down to the (now) floor of the bowl. Make sure you have a good filter & genuine Holley replacement needle/seat assy's I'm sure would be a good idea. When it starts & is idling put a rag under the sight plug(s) & remove it & I think you want the wet level so it just dribbles out if you rock the eng slightly (others will clarify that), been with Eddys for decades