Quote:

I am using the stock 6 cylinder k member with all motor mounts removed. The motor will set in and locates in the correct height and centerline location. The only issue is the motor mount insulator on the left side is almost on the k member which is not an issue being I am making the mounts on the k member for mounting. Are there any other issues using the 6 cylinder k member with a 426 hemi?



This is a 6 clyinder K-member in with a cross ram hemi. Use the stock 67-72? trans crossmember with square type mount. This is for the new TTI hemi A-body headers.





Last edited by autoxcuda; 04/21/13 07:48 PM.