Hi all

I,m triying to degree a Lunati cam and my question is about the cam chart,more precisely the part where it says:"The above centerline will make this cam 4º avanced".
Here is my cam chart:
http://www.lunatipower.com/CamSpecCard.aspx?partNumber=60303

Does this mean that i need to start setting the timming gear on +4º key?

I,m triying to do it following all the steps from this page http://www.lunatipower.com/Tech/Cams/HowToDegreeACam.aspx
and i,m gettin 49 º at 0.050 lift when i would have to be getting 7º!!

I don,t know whats the matter here,or what i,m doing wrong.

Thanks in advance.