p1762

Check engine light is on, code P1762 - Governor Pressure Sensor Offset Volts Too Low or High - is set.
Average Reported Mileage:
85717
Tests/Procedures:
1. Test the voltage on the governor pressure sensor using a scan tool. Normal value is about 0.5 volts at key on engine off.

2. Monitor the voltage on the sensor as the vehicle speed is increased. The voltage should increase. At 20 MPH the voltage should be approximately 1.2 volts. At 40 MPH the value should be approximately 2.25 volts. At 60 MPH the voltage should be approximately 3.0 volts.

3. Verify the operation of the Oxygen (O2) sensors. A downstream O2 sensor fault or wiring fault may cause this code to set.