hi, while driving along in my 68 dart, it never missed a lick, then it like coughed then took off then died..

after a few cranks it started and i drove home where it died again in my drive.

well i found out im not getting any fire..

so i figued a wire (electronic conversion) came loose or something.. well nothing looks loose all connections are soldered in.

so after swaping everything from the sun, I decided to swap out dist.. I used my 410 stroker (non vac advance dist) and it fired right up..

humm so i swaped in the reman one and nothing..

so off to advance i go, i exchange the dist, installed it and it started, now i have a stumble and a miss. just doesnt soud like it did before the problem started..

could the reman dist still cause this? I checked the gap in the pick up coil. i set it from .008 to .0010 and that didnt make it better or worse..

I swappped caps, coils, rotors.. ect... now im off to pull the plugs.. but i cant see why they would miss now when it didnt miss before the pickup coil went bad..