throw-out bearing install/is this right?

Print Thread

throw-out bearing install/is this right? #1211065 04/06/12 06:18 PM 04/06/12 06:18 PM
Joined: Feb 2003 Posts: 2,138 tucson az F frank OP top fuel
frank OP top fuel F Joined: Feb 2003 Posts: 2,138 tucson az	Installed the new fork in the stock bellhousing. Installed the bearing on the fork. The bearing is not even close to being centered over the pressure plate fingers. I can move the bearing against the springs and get more centered but it will not stay in this position. Is this normal?? According to Brewers I need .040-.060 clearance between the bearing and the fingers. According to Brewers all parts are correct. Please advise. Thanks

Entire Thread
Subject	Posted By	Posted
throw-out bearing install/is this right?	frank	04/06/12 10:18 PM
Re: throw-out bearing install/is this right?	Moparlar	04/06/12 11:19 PM

Hop To