Challenger Drive shaft question 904 to 727 TF

Print Thread

Re: Challenger Drive shaft question 904 to 727 TF [Re: fireeng] #1197675 03/15/12 07:37 PM 03/15/12 07:37 PM
Joined: Jan 2003 Posts: 25,992 Rio Linda, CA John_Kunkel Too Many Posts
John_Kunkel Too Many Posts Joined: Jan 2003 Posts: 25,992 Rio Linda, CA	If the u-joints in the 727 slip yoke are the same as the u-joints in the driveshaft you will just have to shorten the driveshaft four inches. If the u-joints in the slip yoke and rear end yoke are different you'll also have to use conversion u-joints. The INTERNET, the MISinformation superhighway

Entire Thread
Subject	Posted By	Posted
Challenger Drive shaft question 904 to 727 TF	fireeng	03/15/12 11:22 PM
Re: Challenger Drive shaft question 904 to 727 TF	John_Kunkel	03/15/12 11:37 PM
Re: Challenger Drive shaft question 904 to 727 TF	BDW	03/16/12 12:22 AM
Re: Challenger Drive shaft question 904 to 727 TF	biginchmotor	03/16/12 02:06 AM

Hop To