I have a set of Isky BB rockers that I had RAS bush for me. Now that they are on the motor, (which is on the stand) I have a couple of them that are not oiling? It's the same for both banks. The ones that are not oiling to the pushrod cup, are the ones that have the valve open. Another thing that I have noticed, is that the rockers are drilled ie through the bushing to allow oil to the valve stem. Everything was taken apart, double cleaned, and I used clevite assembly lube on the shafts. I have their hold downs and ARP studs. I torqued the shafts at 25lbs, when I prime by hand, I notice a fair amount of oil coming past the washer / nut. Is this considered normal, or once the motor is running becomes a moot point considering all the oil pressure? As far as threads showing on the adjusters, it's 2. For the most part I have at the minimum .015 to .025 side clearance (depending on pairs of rockers). Thanks for any insight.