Here are the basics:

1. Caliper brackets bolt in place of the original drum brake backing plates. The sequence of gaskets is unchanged. Caliper brackets face inward and toward rear of car.

2. Install the 5 hole, foam gasket between the caliper bracket and wheel bearing retainer.

3. Mount caliper with bleeder valves facing upward.

4. If needed, install washers between caliper bracket and caliper frame, to center the caliper over the rotor. If you are running snap-ring green bearings, you usually need 1 washer per bolt. If you are running OEM wheel bearings, you may have none on one side and two per bolt on the other side.

5. Mount brake line tab 10" from housing end, level with upper rear housing end studs.