Threads Created By jbc426 - Moparts Forums

Threads Created \| All Posts Threads Created By jbc426
Title	Forum	Post Time
Which flying magnet dampner fits w/o misalaigning pulleys?	Moparts Question and Answer	03/15/23 12:57 AM
Pics of 5.2 Magnum motor mounts for a 95 Dakota?	Moparts Question and Answer	06/07/22 05:30 PM
Quench: parallel or tapered squish area?	Unlawfl's Race & Engine Tech	01/27/22 06:34 PM
Measuring and correcting Bump Steer	Moparts Question and Answer	12/31/21 04:20 PM
How much compression increase when spraying methanol?	Unlawfl's Race & Engine Tech	11/07/21 05:34 PM
No-see-um's, or swapping to EFI under Shaker hood.	Unlawfl's Race & Engine Tech	06/13/21 04:37 PM
Dang, my Mopars are surprisingly heavy.	Moparts Question and Answer	05/04/21 06:27 PM
Progression Ignition's programable dist, initial review	Unlawfl's Race & Engine Tech	05/10/20 05:16 PM
Magnum threaded fan mount extension??	Moparts Question and Answer	04/10/20 05:44 PM
Vacuum advance Distibutor ??	Unlawfl's Race & Engine Tech	04/10/20 05:39 PM
Rear suspension porposing on hard acceleration in 1st & 2nd	Unlawfl's Race & Engine Tech	02/28/20 03:55 AM
Why wouldn't you want quench in a supercharged motor?	Unlawfl's Race & Engine Tech	11/14/19 04:38 PM
Use of compression fittings on steel tranny cooler lines?	Unlawfl's Race & Engine Tech	01/18/19 06:22 PM
Rear shocks are an inch too short. Does it matter?	Unlawfl's Race & Engine Tech	10/17/18 05:25 PM
Car is quickly wearing out Green bearings on one side?	Moparts Question and Answer	12/10/17 06:34 PM
Quench pad shape, angle and matching combustion cham design?	Moparts Question and Answer	11/02/17 04:54 PM
B3 Racings's Indy EZ's & T&D rocker arm geometry correction	Unlawfl's Race & Engine Tech	07/10/17 06:09 PM
High-quench, reverse-dome pistons look cool	Unlawfl's Race & Engine Tech	02/18/17 07:30 AM
Fuel tank mods to improve fuel scavaging.	Unlawfl's Race & Engine Tech	02/13/17 04:57 AM
Pics of carb mounted switches triggered by throttle position	Unlawfl's Race & Engine Tech	01/30/17 04:02 AM

Page 1 of 5