Posted By: BDW
Water pump belt engagement - 03/05/22 11:39 PM
5.7 motor with Holley PS pump
Always thought you wanted at least 25% of the pulley covered by belt?
Water pump looks much less, I guess it works that way from the factory?
Posted By: SNK-EYZ
Re: Water pump belt engagement - 03/06/22 09:49 AM
It didn't look correct to me, but I found this pic online.
Posted By: BDW
Re: Water pump belt engagement - 03/06/22 01:36 PM
Thx for the confirmation, didn't seem right to me either.
The thing that made me question it, is the Holley instructions for the PS pump install.
They specify a serpentine belt that is 6" too long, luckily I measured before ordering.
Oh well, on to the next step of this project, at this rate I'll have it finished by Christmas.
Posted By: John_Kunkel
Re: Water pump belt engagement - 03/07/22 05:53 PM
The common lore says that 60° (one-sixth) of the pulley diameter needs to be in contact with the belt.
Posted By: HotRodDave
Re: Water pump belt engagement - 03/07/22 09:46 PM
A water pump has much less load than a PS pump or even freon compressor, that contact will spin it up just fine.
Posted By: larrymopar360
Re: Water pump belt engagement - 03/08/22 01:06 AM
I know you've already gotten the confirmation you needed, BUT...I looked at 2010 Charger police and looks exactly like yours.