........

So i got a good deal on a 4.125 aluminum block. Just letting you guys know

Im not into gen3 stuff but im impressed and a bit jeoulous.

I know there not cheap, a good deal could be 3k for all I know.

3k would be a good deal on any aluminum block

Ive seen some bare A8 blocks price at 2500 up.

There was talk a while back about an updated version of the aluminum block. Do you know any details about that ?

HHP has blocks that are heavier than the Arrow racing block i got. I think the HHP blocks are around $5500

Thanks, I though Mopar had revised theirs, but who knows. Was yours a private seller or vendor ?

Now you're going all pro mod on us

This I heard also!
Something to do with strengthening ribs on the block?
Matt

Thanks for keeping us in the loop.

By next this year's Drag Week that car is going to so light you will have to tether it like a blimp in the pits!

Good Luck,
Bill

Care to elaborate a little more?

Pretty sure he might know of somewhere with a small stash of them that are gonna go quick and cheap, or he snagged one from someone used.

I bought it from a fellow moparts member. He went with the new block. I wasnt even going to grab it but my friends talked me into it. What are friends for.

So now Im building a whole new motor. A little more cam. Not much. Im going back with the apache heads because the low lift numbers are just better then my experimental eagles.

Motor is going to get some more compression and drag pak oil pan. Not a huge fan of the milodan pan although I cant say I had any problems with it

426 going in the Van?

I measured that a while back. It would be a very tight fit

Don't forget me Bro😜

I have that part covered