Posted By: RobX4406
Dana 60 width? - 02/03/08 07:19 AM
I know that list in the tech archives is jacked up.
I have a Dana 60 that is roughly 56.5" wide flange to flange and thought it may be an e-body. It has the pinion snubber on it.
Anybody have an accurate listing of Dana 60 widths so I can figure this thing out.
TIA
Posted By: DoctorDiff
Re: Dana 60 width? - 02/03/08 07:34 AM
I have posted this several times. Someone needs to put this list in the tech archives.
Dana 60 rearend specs:
'66 B-body 54 1/4" housing, 59 3/8" axle flange to flange, 44" perch 23 spline power-lock sure-grip, 1330 U-bolt yoke
'67 B-body 54 1/4" housing, 59 3/8" axle flange to flange, 44" perch 23 spline power-lock sure-grip, 1330 strap yoke
'68-'69 B-body 54 15/16" housing, 60 1/16" axle flange to flange, 44" perch, 23 spline power-lock sure-grip, 7290 yoke
'70 B-body 54 15/16" housing, 60 1/16" axle flange to flange, 44" perch, 35 spline power-lock sure-grip, 7290 yoke
'71-'72 B-body 57 7/8" housing, 63" axle flange to flange, 47.3" perch, 35 spline track-lock sure-grip, 7290 yoke
'70 E-body 56 31/64" housing, 61 5/8" axle flange to flange, 46" perch, 35 spline power-lock sure-grip, 7290 yoke
'71 E-body 56 31/64" housing, 61 5/8" axle flange to flange, 46" perch, 35 spline track-lock sure-grip, 7290 yoke
Posted By: DoctorDiff
Re: Dana 60 width? - 02/03/08 05:23 PM
Even though the chart located in the tech archives is full of misinformation, correct 8 3/4" specs are also listed.
http://www.moparts.com/Tech/Archive/axle/16.html