Posted By: Mancini Racing
New Gen III Hemi Valve Covers From Mancini Racing
Posted By: GoodysGotaCuda
Re: New Gen III Hemi Valve Covers From Mancini Racing - 12/21/18 05:47 AM
Those look nice, but I don't have any interest in Holley sniper engraved into the surface. A pretty small percentage of Hemi owners run a Holley EFI setup on them.
The Mr. Gasket variant would appeal to a wider market and show to be a little less expensive even.
https://www.holley.com/products/accessories/valve_covers/parts/68501BG
The Mr. Gasket variant would appeal to a wider market and show to be a little less expensive even.
https://www.holley.com/products/accessories/valve_covers/parts/68501BG
Posted By: 6PKRTSE
Re: New Gen III Hemi Valve Covers From Mancini Racing - 12/21/18 09:19 PM
I agree. I never advertise. I weld up/fill etched or machined in logo's, machine off raised castings, peel off decals or labels or whatever needed to remove the manufacturers name off of the products.
Posted By: Dragula
Re: New Gen III Hemi Valve Covers From Mancini Racing - 12/24/18 08:05 PM
Originally Posted By 6PKRTSE
I agree. I never advertise. I weld up/fill etched or machined in logo's, machine off raised castings, peel off decals or labels or whatever needed to remove the manufacturers name off of the products.
Same here, unless it was free....