Posted By: AutoEngineer
Max lift on stock 906 heads? - 04/04/11 09:26 PM
What is the max cam lift on stock 906 heads with stock valves and stamped steel rockers?
Max lift on stock 906 heads?
Posted By: JohnRR
Re: Max lift on stock 906 heads? - 04/04/11 10:02 PM
Have the valve guides been trimmed or as delivered from mopar ?
Posted By: dragram440
Re: Max lift on stock 906 heads? - 04/04/11 10:25 PM
I ran a voodoo with 533 and worked great changed it to a voodoo with like 550 and it wouldnt rev past 6200 rpm. Could have been the springs but I assumed I had some interference with the stock 906 heads.
Posted By: BDS871Cuda
Re: Max lift on stock 906 heads? - 04/04/11 10:35 PM
500-510 range is safe
Posted By: scatpacktom
Re: Max lift on stock 906 heads? - 04/05/11 03:14 AM
Just measure it, why speculate?
Posted By: JohnRR
Re: Max lift on stock 906 heads? - 04/05/11 02:45 PM
Quote:
Just measure it, why speculate?
That would only make sense , but I think his more important question is how much lift can stamped steel rockers handle ?
Posted By: pro6pakRR
Re: Max lift on stock 906 heads? - 04/06/11 04:08 AM
Quote:
What is the max cam lift on stock 906 heads with stock valves and stamped steel rockers?
I run a Mopar 533 hyd with bone stock 346 head's,rocker and pushrods,in my 12.50 engine.
Posted By: 52savoy
Re: Max lift on stock 906 heads? - 04/06/11 07:09 AM
Quote:Quote:
Just measure it, why speculate?
That would only make sense , but I think his more important question is how much lift can stamped steel rockers handle ?
I've ran a .560 lift with stock rockers and it was together for many years. But then the heads were 915's
Posted By: AutoEngineer
Re: Max lift on stock 906 heads? - 04/06/11 05:40 PM
Quote:
Just measure it, why speculate?
Sorry, but I was not in my garage, when wrote that question and my garage is over 35 miles from my office, and I needed a honest answer because from Hughes Engines they said maximum lift with stock guide height is 0.450". More lift would require shortening the valve guides. I thought it's a little bit low, because I have even earlier used cams up to 0.507 without shortening guides.
Posted By: Junky
Re: Max lift on stock 906 heads? - 04/06/11 07:58 PM
Quote:Quote:
What is the max cam lift on stock 906 heads with stock valves and stamped steel rockers?
I run a Mopar 533 hyd with bone stock 346 head's,rocker and pushrods,in my 12.50 engine.
Stock on top 346 heads, 0.518 lift with room to spare.