help with 904 band adjust !

adjusted the bands on my 904 before going to the track yesterday. made 2 passes @6.74 and 6.75 next 2 passes were 6.80 and 6.79. the 6.80 was in the heat but the 79 was about 12 degrees cooler. but the shift from 1st to second seemed to overlap each other. second to third were fine . is the band to tight or too loose ?

did it do it before the adjustment? if not then just back it off 1/8 to a 1/4 turn and see if it goes away, usually it is a 2-3 shift overlap/flare up problem, how is your tranny built? stock, rebuilt with good part's?

yes it a rebuild with good clutches and steels, did not do it before. so its too tight ?

I adjust my front band 72" lbs & 2 1/2 turns out, my double wrap rear is 72"lbs & 4 turns out.What are your bands adjusted to?

i dont have an inch # wrench ,just always snug up then back off 2 and ahalf. but snug is a relative term.

Quote:

---

i dont have an inch # wrench ,just always snug up then back off 2 and ahalf. but snug is a relative term.

---

"snug" ? ... .... I have just done-it with a little-bitty open-end wrench USING the tip-O-my-finger