Challenger Photos with caltrack split mono leafsprings?

I'm planning to order Mono split-leaf spring
anyone have some photos how the car (Challenger) sits with Caltrac split monosprings with stock height.
I don't want my car any higher, I like as it is. I have new extra heavy duty springs at the moment.
Thanks I advantage for the photos

photo in my sig is stock height with a 28 tire.

i used a +1 spring with a 30" tire

Here's about the best pic I have of the car that shows the ride height. These were +1 but I had to re-arch them another inch for the wheel tyre combo we use.
From memory, your ride height above is a little lower than +1.
HTH's

Apologies for the moronic expression from the driver

Would you be interested in seeing a picture of an E-body Barracuda with stock ride height monoleafs?

295/65/15 Drag Radials w/ a B-body Dana.

Same car with 275/60 ET Streets.

A better side profile shot with the 295/65's.

Car runs Cal-Trac monoleafs, bars, and Rancho 9-way shocks.

Here's my 'cuda w/ stock ride height mono springs. 295-65 radial.

My sig pic is stock height mono's with my 295/50/15 (26.5" tall) street tires. I also run 28x12.50 ET streets with no problems.

Thanks all for the photos , so my ride height will not change that much when I change to mono springs

Quote:

---

Here's my 'cuda w/ stock ride height mono springs. 295-65 radial.

---

Can you street drive it with those radials, and are they sticky?