Moparts

Check under your MSD distributor cap now!

Posted By: scottydog

Check under your MSD distributor cap now! - 09/29/10 02:30 AM

I just looked under my kids mechanical distributor cap... rust like you would not believe. I can not belive it.. I read on here a while back about squirting wd40, but I didn't think it would this bad. Just a warning for you guys to check it out.
Posted By: mopar376d

Re: Check under your MSD distributor cap now! - 09/29/10 03:29 AM

Just put a MSD in my car I had laying around. Rust like you said. Read the post on here from a while back. Cleaned it with emry cloth and used WD 40. Working good.

Bought a extra pickup just in case.
Posted By: thehemikid

Re: Check under your MSD distributor cap now! - 09/29/10 06:45 AM

...1st noticed that about 4 yrs ago. If it set's very long, it amazing how much rust you can dig out of there!
Posted By: jbc426

Re: Check under your MSD distributor cap now! - 09/29/10 07:17 AM

This is a good reminder. I read a post about this a while back. When I bought one, I sprayed the inside with Zep45- a commercial grade WD-40 like spray. It hasn't rusted a bit in 2 years. My buddies, on the other hand, was starting to rust pretty good when we had it opened up to shorten his advance curve so he could run more initial timing.

Attached picture 6222704-IMG_1135(Large).JPG
Posted By: jamesc

Re: Check under your MSD distributor cap now! - 09/29/10 07:39 AM

those things rot terrible in a new york minute. not sure if it's materials, ozone, moisture or all of the above. ended up disassembling mine glass beading the internals and spraying it with a preservative coating.
Posted By: Scamp408

Re: Check under your MSD distributor cap now! - 09/29/10 10:43 AM

I took the reluctor off a and painted it bought the cap with the holes drilled in it and never had a problem again. Also put a little lock tite on the rotor screws they have a tendency to back out.
Posted By: sunroofgtx

Re: Check under your MSD distributor cap now! - 09/30/10 12:37 AM

Cap after cap that racers took off at the CC at Norwalk, were rusty..

EDIT>. Not the cap. the reluctor and misc. parts under there.. I heard that their terminals are aluminum with brass coating.
Posted By: joedust451

Re: Check under your MSD distributor cap now! - 09/30/10 12:57 AM

I better check mine then, its been about 6 months sence i bought it new & i'm in a VERY humid area. This is the one i have, did they have the same issues??

http://www.jegs.com/i/MSD+Ignition/121/8534/10002/-1
Posted By: codfish

Re: Check under your MSD distributor cap now! - 09/30/10 01:07 AM

I too live where there is high humidity, but no rust under mine.

I did drill a couple of 1/8 holes in my MSD cap when I put it all together two years ago. Had the cap off last week, and it still looks good.

codfish
Posted By: nss guy

Re: Check under your MSD distributor cap now! - 09/30/10 01:36 AM

Not just rust on the cap but the reluctor and pickup also.
The Firecore Dist. doesn't seem to have these issues
Posted By: joedust451

Re: Check under your MSD distributor cap now! - 09/30/10 02:17 AM

Quote:

Not just rust on the cap but the reluctor and pickup also.
The Firecore Dist. doesn't seem to have these issues




Which one is the "Firecore"?
© 2024 Moparts Forums