Posted By: V10nacuda
B-1 Header gaskets???? Is there such a beast??? - 04/15/10 05:16 PM
Well I pulled the motor out to clearance the frame rail & shock tower to allow for more room to install the headers.
I know alot of you guy's use just silicone & NO GASKET. But I don't know how tight your engine bay is But I have to install the headers in the correct order loos without bolts & then once they are all in place put them up to be bolted on....There is no room to install any silicone.
So today I put a set of Mr gasket ultras on & as expected the port was too small. I can enlarge the port in trhe gasket to match....
DOES ANYONE HAVE ANY OTHER SOLUTIONS?????
FOr those that just use silicone do you install it wet???????? Or let it set up & then install????
V10
I know alot of you guy's use just silicone & NO GASKET. But I don't know how tight your engine bay is But I have to install the headers in the correct order loos without bolts & then once they are all in place put them up to be bolted on....There is no room to install any silicone.
So today I put a set of Mr gasket ultras on & as expected the port was too small. I can enlarge the port in trhe gasket to match....
DOES ANYONE HAVE ANY OTHER SOLUTIONS?????
FOr those that just use silicone do you install it wet???????? Or let it set up & then install????
V10