Best shelf Roll cage..what are you using?

What are you guys using for a shelf roll cage and how do you like the fit, and finish...

Im looking at a Chassis Engineering, or a S&W Kit...
Price between the two is similar..

I also looked at a Jegster..They are very reasonably priced..
Im looking at a 12-14 point BTW

That is a good question Bob..
My experience is that most of if not all the cages out there are off quite a bit. The last one I bought(Chassis Eng.12pt) wasn't even close. I had new forward bars bent for the A-pillars because there was no way CE's would come close to fitting. I'm thinking about bending my own for the Savoy.
Good luck!
Fred

I've got a 10-point S&W for a 68 B-body, pretty decent for the price although I think the front bars could have followed the windshield posts a little closer. From the seat though they line up with the post so there is really no more vision restriction than from the edge of the windsheild itself. They may have improved the fit by now, I got that kit in 97-'98 I think. BTW it can be upgraded as most kits can to a 12-14pt.
-------
Yeah I guess A-pillars was the term I was trying to remember. They say your memory is the second thing to go........I forget what the first is....

R&J installed my CE bar and he said it was one of the better kits he had worked with but, it`s just a bar so who knows about their cage kits.

alston fit nice

Any scouting reports on Art Morison ?
They talk a good game with CAD design etc. and they price for mild steel was pretty fair.

Bob..I have an Alston Chassisworks cage kit...I opted for the rear bars that retain the rear seat and the alston swing out door bars...It fit pretty decent. But no kit will fit like a custom one will.

I have alot better luck with the S&W than the jegs kit..

Well just ordered the Jegster Kit...I will report my findings...I wont be a big deal if the tubes need tweeked I have a bender and notcher all though cheap ones they do a ok job, and one 20' stick of tubing also.

S&W kits here.

Just finished welding in my new one from alston.
It was a 12 point kit from Alston. I like how tight I was able to get it with a little dash alterations. I dont know why they dont send floor plates for the rear bars however. All you get in the kit is 4 main front floor plates. Main hoop you have to pull together with a cumalong to get away from the sides to weld all the way around.
12 point cost $450 with one swing out kit. I drove to sac to get it. Front bars you have to ben yourself.

picture # 2

pic # 3

Well
The A pillar pars is what I am worried about. I hope the fit tight against the firewall and window pillars, so a I just notch the dash and be done with it..
I also want the dash bar to be tucked under the dash, and provide a mount for the home fab'd steering column I am making.
Pretty simple and light is the main issue. I just ordered a Flaming River Universal U-Joint that replaces the old rag joint with a new joint, a piece of 3/4 tubing, etc a light weight steering wheel and wheel disconnect.
Should save 20+ lbs over the factory steering column setup

I have learned that the cheap cage kits all use .134" wall welded seam tubing and not .120 DOM tubing which adds a fair bit of extra weight.

Quote:

---

I have learned that the cheap cage kits all use .134" wall welded seam tubing and not .120 DOM tubing which adds a fair bit of extra weight.

---

Even my Alston cage kit is welded seam tubing...DOM is certainly lighter.