Posted By: Bubba
440-1 Headers for a B-Body? - 10/03/09 11:48 PM
What are my Header Options on 440-1 Heads in a B-Body with an Automatic, Manual Steering and Brakes?
440-1 Headers for a B-Body?
What are my Header Options on 440-1 Heads in a B-Body with an Automatic, Manual Steering and Brakes?
Posted By: Old School
Re: 440-1 Headers for a B-Body? - 10/03/09 11:49 PM
tti 2" step headers ,fit like a glove...
Posted By: sixpakdodge
Re: 440-1 Headers for a B-Body? - 10/03/09 11:55 PM
Don't look at Hooker Super Comps. I had to go to Hedman Huslers.
Posted By: 69CHARGERMD
Re: 440-1 Headers for a B-Body? - 10/04/09 12:24 AM
Bubba,
you going to run the 440-1 on your "street" car,,,,should be sweet..........
you going to run the 440-1 on your "street" car,,,,should be sweet..........
Posted By: Bubba
Re: 440-1 Headers for a B-Body? - 10/04/09 02:02 AM
Not 100% sure yet Doc. I may just try to sell or trade the top of my current setup for something alittle more sissish...
Posted By: an8sec70cuda
Re: 440-1 Headers for a B-Body? - 10/05/09 12:01 PM
Your only 2 options are the TTI 2" to 2 1/8" step headers or the Hedman Husler 2" headers. Those are the only 2 off the shelf underchassis headers made for B and E bodies that will fit the raised port heads that I'm aware of. I have the TTI step headers. They're very nice and fit really well. CHIP
Posted By: 68roadrunner
Re: 440-1 Headers for a B-Body? - 10/05/09 12:10 PM
Quote:
tti 2" step headers ,fit like a glove...
they only hit the trans shield, just a little tweeking needed
Posted By: Bob_Coomer
Re: 440-1 Headers for a B-Body? - 10/05/09 01:25 PM
I ran that very setup in a 69 Coronet. Those TTI stepped headers was the best fiting shelf header I have ever owned. 
Posted By: racerx
Re: 440-1 Headers for a B-Body? - 10/06/09 12:57 AM
Quote:
I ran that very setup in a 69 Coronet. Those TTI stepped headers was the best fiting shelf header I have ever owned.
Same here except on a e-body 
Posted By: ramcharger1964
Re: 440-1 Headers for a B-Body? - 10/06/09 03:14 PM
I just installed a set of the TTI's in my 64 Polara with a new Damon Kuhn RB last week. I have power steering and brakes and they fit just fine. I have about 3/16 clearance from the steering box to the headed tube which was the area I was worried about!
Posted By: Bubba
Re: 440-1 Headers for a B-Body? - 10/07/09 01:47 AM
Does anyone have the Part number for the Husler headers?