Posted By: Badfish67
Small Block Edelbrock heads CNC ported? - 08/22/09 04:08 PM
Does anyone know who CNC ports Edelbrock heads?
Posted By: DaKuda
Re: Small Block Edelbrock heads CNC ported? - 08/22/09 04:10 PM
hughesengines.com around $2500 if I remember for the heads CNC'd
Posted By: 70AARcuda
Re: Small Block Edelbrock heads CNC ported? - 08/22/09 04:25 PM
Posted By: 68DART360
Re: Small Block Edelbrock heads CNC ported? - 08/22/09 04:32 PM
Jeff @ MCH was great to deal with when he did mine last year.
Posted By: sshemi
Re: Small Block Edelbrock heads CNC ported? - 08/22/09 05:56 PM
Not to high jack but would this be the best bang for the buck if you want 550-600hp?
Posted By: Badfish67
Re: Small Block Edelbrock heads CNC ported? - 08/22/09 09:34 PM
Anyone have an idea what the cost is to CNC port the Edelbrock heads?
Posted By: 70AARcuda
Re: Small Block Edelbrock heads CNC ported? - 08/22/09 09:44 PM
well..if you can wait..
modern cylinder head has winter special ....
I paid 800 dollars which includes cnc the heads, the valve job and reassembly of the heads..this was on a new set of sb eddy heads that i shipped to them.
also included port flow sheet on intake and exhaust port..
Posted By: Badfish67
Re: Small Block Edelbrock heads CNC ported? - 08/23/09 05:28 AM
Hey AAR...
The CNC port job you got from MCH, is that the most that the Edelbrock heads can be ported? And yes I can wait till the winter.
Thanks
Posted By: 70AARcuda
Re: Small Block Edelbrock heads CNC ported? - 08/23/09 07:57 PM
also. if you use a 2.05 valve the intake will flow over 300 cfm..
Posted By: Badfish67
Re: Small Block Edelbrock heads CNC ported? - 08/23/09 08:25 PM
Thanks Tony...
This winter i'm going to send my heads to MCH for some porting and maybe some 2.05's.
Posted By: BobR
Re: Small Block Edelbrock heads CNC ported? - 08/23/09 09:20 PM
RyanJ hand ported mine with 2.05 valves and they peak out at 285 on his flow bench-but are 285 from .500 lift up.. There is a lot of difference in flow benches so flow numbers are only a guideline. If you need a true 300+ cfm you may want to get better heads.
Posted By: dusturbd340W5
Re: Small Block Edelbrock heads CNC ported? - 08/24/09 02:14 AM
my CNC IndyBrocks flow over 300 on Ryan flow bench with a 2.05 intake valve
Posted By: Scamp451
Re: Small Block Edelbrock heads CNC ported? - 09/11/09 11:20 PM
If he does run this special or group buy, I think it is usually listed in the hot deals section. If I end up geting a set, this could be an option.
Posted By: patrick
Re: Small Block Edelbrock heads CNC ported? - 09/12/09 05:47 PM
Posted By: cudadave72
Re: Small Block Edelbrock heads CNC ported? - 09/12/09 06:18 PM
Have you checked with Shady Dell? I dont know if they CNC but that is where mine are headed (no pun intended) of to this winter.