hemi fuell lines ?

hi

does anyone make the stock street hemi type lines from pump to carb in 3/8" tubing ?

stock was 5/16 ,

thank you !

I have always just made mine own copying the routing and look from factory photos. You can buy the fittings and junction blocks at most any auto parts stores.

Finding the proper size 3/8 inlet fitting for the OEM Carter OEM Hemi carbs may be a challenge
I think that Mopar did offer the 1967 SS RO and the Plymouth cars with those fittings and fuel line size on those year 750 CFM carbs on those cars only

I believe I just used the fuel fitting out of some other Edelbrock carbs I had laying around.

hi ,

what tool do you use to make the close 90 deg bends in the 3/8 line .

bender i have is not the best .

thank you !

These are the ones that I bent up myself for the Edelbrock carbs on the 572 Hemi that I put in the 67 Satellite.
The T-block came from Summit.

The 66 to 67 had a 3/8" from pump up to T. You may be able to purchase that separate from the manufacturer. The T had center 3/8" but switched to 5/16" to the carbs. So you would only need to make those. The 3/8" double 5/16 is unique but a triple 3/8" more common.

hi


nice job .

i am trying to copy the factory line set i have in 3/8 so i can use the factory large dome air cleaner .

had a rusel type line front to rear carb but i stuck out from rear carb to far that base would not sit down on carb .

so bend in my lines have closer bends like stock ones , wish i had a bender to make the close bends easy ?

my coil is in stock location also .

waiting on some new fittings now .

heater hose are there also ,

supprised some one does not make this ?

I used the chrome dome air cleaner on mine.
The idea was a 572 Hemi that looked basically stock.

I had the same idea because I like the stock look also. Well, sort of.