TF 240 cnc program

Does anyone have a cnc program to take the 240 heads to max wedge?

Also need my roller cam repaired. Who could I send it to. It's a Howards..It looks a little rough.

Thanks,
Mike

...sell your 240's and buy 270's

I hear they recently went up 200.00 per head.

..no stock at summit too,I suppose there might be a special case

440Source has 270's in stock.

Yep, Summit raised them at same time they were handing 10% off out at the Nats like Candy..... New price is almost dead on old with the 10% off.....

Plenty of competent head porters can open a standard port to MW; doesn't require a CNC program.

Have you contacted Howard's about the cam? Depending upon the issue, it may not be cost-effective to try and repair it.

Thanks for the ideas.

Mike