HELP! I need an unmolested Indy 400-3 intake

Hey, I need a 400-3 intake for my 498" Brodix headed Bonneville bullet. If you have one or know of one, please let me know. Undy does not have any available at this time. Thanks

Thought I had one but it is a tall deck. Good luck with your search.

Thanks for looking!

I have one that is fully molested and setup for a 4500 carb...I might consider selling.

Indy manifold on B1 heads?

prob budget sportsmans

I'd bet he means the 3X Indy. Those B1 intakes are pretty good though. I'm wondering if you have a scoop/turbulance issue. Like someone mentioned simple AND CHEAPER AND EASIER TO PACKAGE. Individual EGT's are adequate to determine distribution. This is the way we used to in NASCAR and they ran WOT for more than 9 seconds too.

Actually, non-budget fully ported B1MC heads with 2.4" Ti intake valves. Ports actually too large for this application. Need a smaller port manifold that can be ported for good flow then installed with the mis-match at the head.

HardcoreB, this B1 instake flows well for what it was designed and ported to do, but it was not ported for land speed racing, heavy load at speed. Car (1969 Daytona clone) ran almoat 231mph as is, but I agree turbulence at the carb had a lot to do with the problems of distro. Moroso DS-2s that grew 2 1/2" in diameter at that speed caused the final drive ratio to be way too high, compounding the problem.

Still need an uncut Indy 400-3.
Thanks

Are the DS2 tires allowed to run above 175.+MPH by SCTA and BNI now?

Hughes Engines sells that low deck INDY 400-3 (4500) intake and they’re in stock.
https://www.hughesengines.com/Index...w==&level2=SW5keQ==&partid=23648

EDIT: Their checkout leads a person to believe they're in stock. LOL

I don't know how your application is any different than a NASCAR engine? Other than a restrictor motor, any intake i have even seen has been ported in a conventional way with no reduction in cross-section.

Just talked to Hughes, none in stock and no ETA on any coming in, I am looking for one also.

I just thought of it but did any of you guys contact Moparts member Jack Moore
He always has stuff laying around.

Yes, no problem.

Hey, can't find a Jack Moore on here. If you can get me in touch with him I will appreciate it. Just spoke with Indy yesterday. They said the manifolds should be poured today and available in 4-6 weeks. But that is the same story they told me just over two months ago. Hopefully they will be available soon.

try Moore and Moore racing.
He usually start postings his end of the year adds on here about now

He has been listing some stuff on Facebook.

If I see Jack in canton this weekend I will get his number for you

Gus

I talked to Jack last weekend and mentioned someone here was looking for a manifold , he said he'll check it not sure he got around to it judging by the previous posts

IMG_2211 (2).JPG (68.87 KB)
If this it check Moparts race section.

Not sure, but it is already sold.
Thanks anyway!

Found Jack's fb page, thanks.

Good luck