Show us your crank scrapers and windage trays

Diy or professionally made. Rudimentary to prostock level, let's see them.

Edit: I should have specified B/RB/Hemi.

How long is a piece of string?

Of coarse the actual wiper has to be custom fit to crank and rods but the rest is what I am interested in.

1. With a skirted block will the wiper extend up into the crankcase? Would the angle be important?

2. How is it mounted? Sandwiched like a factory windage tray requiring three gaskets when used along with a windage tray? Or ?

3. Drain back? holes/slots/ louvers/ screens

4. Wiper on one side or both sides?

5. Will it need gussets or beads to stiffen it or will just thin sheet metal be sufficient?

6. Made with Steel, aluminum, plastic, unobtanium?

I've built 2 of them.. both were made of steel and Teflon.. these were for my small blocks.. one was for
my 3.79 stroke and the other was for my 4.00 stroke.. you can buy a finished one if you want
https://www.crank-scrapers.com

This is for a stroker low deck. Teflon inserts and made by Ishihara-Johnson. Dyno results, but no before/after scraper.

Small block factory tray with a few mods.