Posted By: MattW
8 3/4 ID - 06/03/20 03:06 PM
Have an 8 3/4 housing with center section.
Its 56.5 inched wide so E body but cannot find anything on the CS ID.
Its 56.5 inched wide so E body but cannot find anything on the CS ID.
8 3/4 ID
Posted By: Locomotion
Re: 8 3/4 ID - 06/03/20 04:10 PM
Best I can make out is 1634985, which is an earlier version of a 742 case.
moparts 8 3/4" tech archives
moparts 8 3/4" tech archives
Posted By: Cab_Burge
Re: 8 3/4 ID - 06/03/20 05:49 PM
That is probably a early, pre 1961, big car, C body size rear end 
Did you take it out of the housing? If so did it have tapered axles with threaded axle ends and nuts holding the brake drums on? If so it is pre 1965
Did you take it out of the housing? If so did it have tapered axles with threaded axle ends and nuts holding the brake drums on? If so it is pre 1965
Posted By: MattW
Re: 8 3/4 ID - 06/03/20 05:52 PM
Good to know.
Well its not the small pinion.
Guess i didn't look hard enough!!!
Thx
Well its not the small pinion.
Guess i didn't look hard enough!!!
Thx
Posted By: MattW
Re: 8 3/4 ID - 06/03/20 05:54 PM
No i don't think so.
I believe it has the regular adjusters.
I believe it has the regular adjusters.
Posted By: John_Kunkel
Re: 8 3/4 ID - 06/03/20 06:52 PM
Originally Posted by MattW
Its 56.5 inched wide so E body
Could also be a '65-'69 C-body. Difference is the pinion angle.