Posted By: Jeepmon
Quick question answered please... - 05/19/20 11:02 PM
For those of you in the garage right now...
What is the diameter of the register for an 8 bolt crank?
Thats the last bit of info I need before I place an order for a new one to be built..
Thanks
Posted By: Cab_Burge
Re: Quick question answered please... - 05/19/20 11:52 PM
I.D.,O.D., or both?
I think I have a 8 bolt Ohio stroker crank in a motor in the shop I can use to make those measurements from
Or do you want a stock street hemi cranks for those measurements?
Posted By: sr4440
Re: Quick question answered please... - 05/19/20 11:52 PM
walked out to the shop, apox 2.14 also you made me look, it's the same as a 6 bolt crank.
Joe
Posted By: Guitar Jones
Re: Quick question answered please... - 05/20/20 12:08 AM
i think all the modern V8'S are the same. You may run into something different with an old poly or 1st gen hemi. Of course you didn't say what engine you were asking about.
Posted By: Jeepmon
Re: Quick question answered please... - 05/20/20 12:17 AM
Thanks Guys..
This is for a BBM wedge motor, it will have a (Chevy) PG trans, TC and Flexplate, so I think I only need the OD of the register...
The previous build had an Ohio crank in it, but we kinda destroyed that when the motor locked up crossing the stripe at 7300 rpm.. so sent it off to the recyclers..
I think I can live with the 2.14" number
So thanks again
Posted By: 440Jim
Re: Quick question answered please... - 05/20/20 03:43 PM
2.156 OD on my Crankshaft.
This pic are the measurements of my PG adapter with JW bellhousing, ATI flexplate.
Posted By: Jeepmon
Re: Quick question answered please... - 05/21/20 12:38 AM
2.156 OD on my Crankshaft.
This pic are the measurements of my PG adapter with JW bellhousing, ATI flexplate.
Thats perfect.. I literally spend 2 hours searching the internet for a drawing similar to that one..
Thank you so much for your help..