Posted By: Wirenut
Heat valve - 05/06/20 10:22 PM
Hi Folks
I use a heat valve to lean out and warm up my methanol powered engine .
Does anyone know if you can overdo it and hurt anything ? I,m trying to warm it up faster.
Meaning I use a 3/8 line . Could I use say a 1/2 or 3/4 line to lean it more ? Is there a rule of thumb limit?
Also right now it’s plumbed into a carb spacer. I was thinking about taping it into the floor of the manifold. Anybody see a reason not too.
Thanks G
I use a heat valve to lean out and warm up my methanol powered engine .
Does anyone know if you can overdo it and hurt anything ? I,m trying to warm it up faster.
Meaning I use a 3/8 line . Could I use say a 1/2 or 3/4 line to lean it more ? Is there a rule of thumb limit?
Also right now it’s plumbed into a carb spacer. I was thinking about taping it into the floor of the manifold. Anybody see a reason not too.
Thanks G