Moparts

Alcohol Dominator question

Posted By: bobs69

Alcohol Dominator question - 04/04/20 10:09 PM

pro system alcohol dominator that I bought used. Sent back to pro system to refresh long story short the car will die when I put it in gear. Any information will help. Can’t find any vacuum leaks. Thanks
Posted By: madscientist

Re: Alcohol Dominator question - 04/04/20 11:43 PM

Originally Posted by bobs69
pro system alcohol dominator that I bought used. Sent back to pro system to refresh long story short the car will die when I put it in gear. Any information will help. Can’t find any vacuum leaks. Thanks


Thumpr carbs. Dominic. Find him on face book.
Posted By: Mark Whitener

Re: Alcohol Dominator question - 04/05/20 12:35 AM

How many turns out are the mixture screws from fully seated? What size are the idle air bleeds?
Posted By: Cab_Burge

Re: Alcohol Dominator question - 04/05/20 01:40 AM

Turn all four mixture screws out one full turn to see if that helps scope twocents
Are you using both idle speed screws evenly, equal amounts of turns, to set the idle speed? If not try that also thumbs
Posted By: dart games

Re: Alcohol Dominator question - 04/05/20 10:41 AM

dont contact thumper carbs he only does gas carbs,no alky or e-85
Posted By: dart games

Re: Alcohol Dominator question - 04/05/20 10:43 AM

this is for e-85 can try this

Attached picture 86733937_3040538199319174_7173645868896092160_n.jpg
Posted By: madscientist

Re: Alcohol Dominator question - 04/05/20 01:50 PM

Originally Posted by 69b1dart
dont contact thumper carbs he only does gas carbs,no alky or e-85


My bad. I forgot about Dom not doing alcohol based fuels.
Posted By: Wirenut

Re: Alcohol Dominator question - 04/05/20 02:58 PM

Originally Posted by bobs69
pro system alcohol dominator that I bought used. Sent back to pro system to refresh long story short the car will die when I put it in gear. Any information will help. Can’t find any vacuum leaks. Thanks


Don’t know much about dominators but I do run methanol via carb

What fuel specifically are you using?

Is it on the idle circuit ?
Or is curb idle turned up to high?

What’s your timing situation?

How radical is this engine? Cam , compression etc.

This setup all works well with a different carb?
© 2024 Moparts Forums