Posted By: Milan454
Mechanical six pack budget build. - 08/21/19 11:38 PM
Hey guys and gals. I'm in the final building stage of my 440 six pack Challenger. I finally have the pieces parts together. I'm going with 3 2300 series carbs I've set up to work with my edelbrock six pack manifold. My center carb is a 300 CFM carb and my outboard carbs are 350cm carbs. I want to keep velocity at the carbs healthy so I chose something smaller than max cfm. I have been searching the forums and they have been very helpful. I'm pretty sure my carb choice is somewhat unique. I found the info below in the forum history. I'm looking for suggestions regarding jetting, squirters and PV specs for primary and outboard carbs in light of the smaller venturies.
Stock jetting on the center carb, List # 4782 is 64 jets with a power valve and #31 squirter, the outboards call for #82 jets with #28 squirters. Measure the vacume in gear at a idle ROM and use a power valve lower than what it idles in gear(1 to 3 inches)
TIA
Milan
Stock jetting on the center carb, List # 4782 is 64 jets with a power valve and #31 squirter, the outboards call for #82 jets with #28 squirters. Measure the vacume in gear at a idle ROM and use a power valve lower than what it idles in gear(1 to 3 inches)
TIA
Milan