Posted By: justinp61
SB oil pump help - 04/20/19 02:07 AM
Does anyone have a link or the specs for the rotor/gerotor clearances? I thought it was in the archives here but can't find it.
Posted By: sg1093
Re: SB oil pump help - 04/20/19 01:13 PM
From a 1971 Service Manual, between outer rotor and pump body, more than .014, replace. Between inner and outer rotors, no more than .010.
Posted By: RapidRobert
Re: SB oil pump help - 04/20/19 05:49 PM
Justin are you haveing a psi issue or just checking one on the bench?
Posted By: justinp61
Re: SB oil pump help - 04/20/19 07:50 PM
Robert I'm checking the pump clearances while it's out. The pick up tube broke off in the pump so the pan is off and the pump is out. I think I'll ad a shim to the bypass valve while it's out, this engine is built pretty loose.
Posted By: CMcAllister
Re: SB oil pump help - 04/20/19 08:22 PM
Clearance over the rotors - .004" max
Outer rotor to body - .014" max
Tip clearance between rotors - .010" max
These are max numbers for replacement. I would want them to be tighter on anything that matters. You can snug up the clearance over the rotors by facing the body with some fine paper on a smooth, flat surface. .004" is a big gap to be losing oil through.
Posted By: justinp61
Re: SB oil pump help - 04/20/19 09:36 PM
Thanks guys. I have .0025" cover to rotors, .005" between the housing and outer and as marked in the images below.
Posted By: Cab_Burge
Re: SB oil pump help - 04/21/19 12:39 AM
How much depth on the scroll and rotor to the pump housing?
Posted By: CMcAllister
Re: SB oil pump help - 04/21/19 01:01 AM
I think I would try to snug that up some. Give the cover a few swipes too, just to catch any burrs or high spots.
Posted By: justinp61
Re: SB oil pump help - 04/21/19 01:36 AM
I think I would try to snug that up some. Give the cover a few swipes too, just to catch any burrs or high spots.
I've already flat sanded the cover and will do the same to the housing.