Question On Oiling

I'm looking for a set of SB flat tappet lifters
with push rod oiling.. I see that Comp Cams
has a 2901-16 solid but I am wondering if it
works with push rod oiling.. I'm new to this
NON roller stuff.. last time I used a flat
tappet cam was in the early 70s... thanks for
the help

AMC lifters are the ones that oil thru the lifter/pushrod.

I see that.. I found out that I want CC 801-16
thanks

Be aware that the pushrod seat of the AMC lifters is higher then the mopar lifter....

Does it still oil the push rods.. thanks

The CC site says yes they both oil & 1.79" seat hite on the Mopar/AMC one & 1.63" on the std SB Mopar one. If they are the same ex for the hite (at least from the descrip it sounds like they are) then I would mockup with a junk lifter with the cup at those heights (I JB welded a hyd one for checking) & Hughes offers an adjustable one for checking (He may rent it out) & see which one gives the best valvetrain geometry. EDIT & I set (JBweld) the cup hite at whatever preload my setup has during mockup, maybe a bit OCD there but its my meticulousness

Check out the lifters on Hughes web site, they are oil through,plus they have the edm hole, they were the ones I was going to run with my w9's, but I went 48' roller