Small block mopar, 727 trans and a mid plate

Well it is time to install a mid platen on my turtle, running a small block Mopar with a 727 transmission.
Any suggestions on a mid plate get and what to do about spacing the converter to the flex plate? ARP make a longer torque converter bolt in a 7/16" for us Mopar people?

I use .090 for the mid plate.. just open up
the starter area so the starter sets against
the bell housing.. I never used a longer snout
on any of my convs

Did you use a flex plate shim or spacers between converter and flexplate?

Saw you posting on that "other" site.I am installing a midplate myself right now.After 15+ years with an engine plate and a rubber trans mount I'm overdue.The midplate came with the crank spacer.It came untrimmed so you can shape it the way you want.

No... it pulls the conv out of the pump .090.. I
never had any issues that way.. if you want you
can shim the conv back with washers

Wow I thought I trimmed my cross member, hope I cut enough.

I'm using the Milodon rear sump Truck pan.

Suggest any vendor to buy from? before I order it from summit racing.

I made my mid plate.. super simple if you have
a trans handy.. just leave a big ear off of
each side

I just ordered a mid plate from summit racing, thanks for all the advice peoples