727 Aluminum Pan

I need another transmission pan 3" or so deep and the filter spacer. Is the B&M OK? Any suggestions?

I already have the factor steel 2 1/2" pan but need a little more clearance.

Thanks.

Summit sells a nice one under their no name deal.

^^^^ this. and I found a nice one on ebay also

I run the B&M aluminum cast pan on my street car, it's HEAVY. Race car has a 265-827 Dorman 518 pan. 3" deep.
Doug

Ditto.....Bought a bunck of them. Got one on each of my transmissions.

Comes with everything:
https://www.summitracing.com/parts/sme-1009r

Does anyone know how thick the spacer is that comes with the Summit pan?

Nice. Makes my MP steel deep pan look rather pedestrian.

Have had that B&M pan. Liked it. Sealed good, didn't leak

All the spacers I've seen are short, around 2" I made a 1" extension'.
Doug

I have one that is 1", it will take 1 3/8-1/2" to clear the tb solenoid. I'll call Summit and B&M tomorrow.

I run the B&M pan. It's nice, has temp sender boss and magnetic drain plug. But I too was surprised how heavy it is. It comes with two stackable extensions. 1-1/4" & 3/8"; stackable to 1-5/8".

Not sure how deep the Cope Racing Transmission pan is, but it is nice with a billet filter extension.

http://coperacingtranscom.ipage.com/?product=727-deep-aluminum-pan

How far off the pan bottom should the filter be?

Thanks guys.

https://www.lpwracing.com/Index.html These guys make some great stuff!

I have one from LPW as well! Great pan! Thick rails and very well made

Yep, bought one for my Dart and used the reusable gasket that Chrysler makes.