727 rear roller support

Does anybody have picture with measurements where should i put the bearing on the support so i dont kill the planets with restricted oil flow. Or do i have to make more oil passages to the support?

Isn't the bearing part of the support assembly?

https://board.moparts.org/ubbthreads/ubbthreads.php/ubb/showflat/Number/7020107/site_id/1


Some good pics and info in the above link

Thanks, found the correct info.

To fully rollerize the rear support, you can cut off the part that the rear drum spins upon. Using bearing B2414 and machining a spacer/bushing to press into the rear drum