Super comps and plug wires...which wires to use?

Ordered a set of Taylor wires for my 440 from summit and ...go figure.... They won't work with my supercomps..what have you guys found to be the best bet?

I only run cut-to-fit wires now, and add ceramic plug boots as an additional safety factor when the boot-to-header clearance is too tight to keep from toasting the traditional plug boot.

Which ones did you order that won't work?

74072...6x 90* 2x 135* boots

Firecore`s here..............

Any issues with header clearance with the firecores?

Im running MSD 8.5 cut to fit wires. They fit perfectly with 2" CPPA/TTI headers on my 440.

I run RPM heads w/angled plugs so no issues and run all of my wires UNDER the tubes against the block................

I got the morose ultra 40 big block Chevy wires with the insulated jacket and stuff ..fits perfect I just cut the numbers off and wrote on the top of the boot which plug the wire went to..

I have Eddy heads and super comps on my car and I also use Firecore wires.

Mine are also run under the headers against the block and have 90 deg plug ends.

i run the firecores, on my lowdeck i needed a 90 degree boot on the #8 cylinder and all others were straight with 440 source straight plug heads, with my indy heads they are angle plug and they take more 90's.

Firecore here also.Rick will make them anyway you need them!!