Long overdue photo updates on my Challenger

Interior is all done. Notched back seat (street car)around the down bars that go to the tops of the spring perches from the main hoop.

New dash pad is on notched around the "A" pillar bars.

Windshield is back in.

back window is back in.

Interior shot.

Passenger side. Before new dash pad was back on.

Block is all machined. Mocking it up for port alignment. Going to be a dual dominator NOS engine to get back out for now until I can afford to do the twin turbos on the Keith Black aluminum engine.

Love it! More details about the nitrous hemi combo?

Plumbing a Fogger in the tunnel ram within the next week or two. I'll start alittle conservative & step it up from there. Several buddies around here are 700+ cubes with 4 kits. I can't hang with them if I tried.

Got NOS!!!

Looking good. Happy to see progress for sure.

Block off plates made. Repainting firewall & snout bars next while the old front suspension is out.

Made some stanchions to keep it mobile for now until I can afford to do the front suspension.

Underside is all cleaned, painted & detailed from the back to the fireall.

A.R.B in the rear.

Very nice !! Thanks for sharing !!

And my favorite part of the car, but worth seeing again. Some have seen it already though.

very nice!!!!!!!!!

Looks Great!!!

Very nice!

Thanks guys. Hoping to debut it next spring. Getting closer. No high expectations. I already know the first season will be ironing out all of the bugs & sorting things out.

So what did you decide as far as dash pad? I think at one time you wee talking bout using a cap, cause the ordinal pads were expensive and you didn't what to cut one up.

Yes, I used a dash cap. Didn't want to pay the big bucks for a re-pop only to cut holes in it for the A Pillar bars to go thru it.

Looks good!

Good luck with your quest. Looks good.
Doug

Love the car, great work...but looking at the seat location...are you like 5"8'?? My thighs started cramping just looking at that!

looking awesome. i love this car.

VFN makes a Fiberglass Dash. That's what I used in my Challenger.

That is going to be a nice piece; looking really, really good! Nice work.

Very Nice !