Posted By: EDDIEB
Thumper Carbs? - 03/04/15 07:43 PM
Any new feed back,results ,good or bad?
Thanks EDDIE B
Thanks EDDIE B
Quote:
Best my car ran in real good air was 9.98 and 1.38 60 @ 135.Most of my runs have been 10.0 cool air to 10 teens in the heat with 1.40 to 1.44 60 foots.
I have since added 20 lbs with exhaust and diaper.
I only got two decent runs out of 5 but i'm sure i can get a tenth with knowing where my tune is for sure now. Keep in mind i'm not much of a tuner and i litterally put that carb on, set the idle and ran it as is. What is hard for me is the addition of the pipes for the 02 sensor, Sounds like i have a miss to me.
As my friend said after the TNT yesterday, We really need to find a chassis dyno if we want to dial them in right
Quote:
Added 18 in extensions with turnouts and they are 3.5
Quote:
Best my car ran in real good air was 9.98 and 1.38 60 @ 135.Most of my runs have been 10.0 cool air to 10 teens in the heat with 1.40 to 1.44 60 foots.
I have since added 20 lbs with exhaust and diaper.
I only got two decent runs out of 5 but i'm sure i can get a tenth with knowing where my tune is for sure now. Keep in mind i'm not much of a tuner and i litterally put that carb on, set the idle and ran it as is. What is hard for me is the addition of the pipes for the 02 sensor, Sounds like i have a miss to me.
As my friend said after the TNT yesterday, We really need to find a chassis dyno if we want to dial them in right
Quote:
MR P i'll take some pix when i get home and post them, Only reason they are on there is for the 02 sensor. I wanted to put them in the collectors but everyone said i needed the extensions so the sensor would read correctly
Quote:Quote:
MR P i'll take some pix when i get home and post them, Only reason they are on there is for the 02 sensor. I wanted to put them in the collectors but everyone said i needed the extensions so the sensor would read correctly
Without knowing your engine the proper collector length
would be in the 16"-18" to make max torque.. so your
extensions might have given you the decrease in the 60'..
just saying
[/quote
Here are the pipes, 18 inch with the turn outs.
Engine combo is 470 B block with little EZ heads
Assume it makes 700 HP.
02 Sensor is on the right side and 12.5 inches past the collector.
Headers are typical hooker 1 7\8 with 3.5 collectors.
Carb is 1150 dominator.
Quote:
What is your body style and how much does it weigh?. Looks good under the
hood [/quote
Thanks,68 Dart
Quote:I agree and this is a different carb than what he ran before so no back to back test and the weather was apparently warmer than the 9.98 best. What fuel do you run and what compression Mikey?
ET, 60ft and all that is great, but mph is power and you are down some. Could be the weather, but you need to jet for mph and then work on the ET.
Monte
Quote:
There's more there for sure but good runs. In thr green is not enuff info so see what's needed to see the gauge and can you post plug pics?
Quote:As we spoke earlier jet up till it slows then we can tweek the high speeds if necessary.
after last run in 90 degree heat
Quote:There is nothing to see mixture wise on that plug. The only thing the threads and strap tell you is heat. The mixture is read off the very base of the porcelain. Out there on the end means little to nothing
after last run in 90 degree heat