critique my setup

850 carb

i would go solid also,victor intake 1" hvh spacer,HP850 carb. whats up Ari!

.030" 440
stock rod
11.5:1 trw
Mildly ported 915's with 2.14/1.81
MP 590/312 solid
m1 4150
1" hvh spacer
750 chokeless race holley
4200 coan
transbrake
456 dana
13x31 et drag
ss springs
3335 lbs with driver

Best et 10.644
best 60 ft 1.401


Very do-able. step up to a solid cam though.

I have a very similar motor, 440+.030 Speed Pro six pak pistons with 9.46 to 1 comp. ratio, LY rods,stock stroke Mopar OEM steel crankshaft, ported 906 heads with 2:14 intake valves, 1.81 exhaust, flow 270 CFM at .600 lift at 28 inches on a Superflow 600 bench(not as good as a set of heads as yours are), RAS 1.6 ductile iron rockers, Comp Cams Extreme Energy Hi Lift hyd. cam, 285 advertised int., 297 adv. EX with .545 lift w/1.5 rockers advertised. the intake is a Eddy Performer RPM with a Holley 950 HP.The motor made 512 HP and 544 FT. lbs on pump gas, it ran a best so far of 11:41 at around 118. mph in my 3400 lb. Duster(with me in it) with the exhaust and air cleaner on, 4;30 gears and 30 inch tall 13.50x30x15 M/T ET Street tires, 10 inch Contintental converter. I didn't get a chance to tune the motor as the oil pump bypass plug and valve came out on the second run I have had a bunch of 440 motors in different race and street cars, all of them liked bigger carbs and none of them like the Torker 2 intake manifold. See if you can get a M1 single plane intake or a Eddy Performer RPM intake and look around for a 850 DP or a 950 HP, both will work better at the track than the 750 will Or better yet use what you have now and go see how fast you can make it run with those parts and then see if you need to try and step it up with other parts experience is one of the best teachers out there, and you can have some fun learning along the way

experience is one of the best teachers out there, and you can have some fun learning along the way

---

True but it can be costly also