Posted By: tntmachine
Installing a Bruno and Lenco in my 64 Fury - 12/31/13 05:34 AM
I'm installing a Lenco 3 sp and Bruno in my 3600 lb Fury drag car. 520cid, ladder bars, 4.56 rear... what gear ratios should I use?
Quote:
I'm installing a Lenco 3 sp and Bruno in my 3600 lb Fury drag car. 520cid, ladder bars, 4.56 rear... what gear ratios should I use?
Quote:
I already have the Bruno and Lenco, just trying to figure out what gear sets I will need.
Quote:Quote:
I already have the Bruno and Lenco, just trying to figure out what gear sets I will need.
Looking at your profile, I see you've been running a TF in the Fury. If you're wanting similar ratios, you would need a 1.68% and 1.44% gearbox, that would give you a 2.42 first gear ratio. There are other combinations that will give you the same first gear, but you have to determine how much of a spread you want between 2nd and 3rd and then plug in the other ratios until you get the first gear you want. Not sure which Lenco (CS-1, CS-2)you have but here is link to all of the ratios available.
http://www.lencoracing.com/HowaLENCOworksandRATIOSmaster.html