Ron's terminator throttle stop

I've got a Ron's terminator injection and was looking for some input as to what throttle stop works best and what if any changes need to be done. Ron's website recommends K&R,but if there are any other options, I would like to hear what you guys are using,thanks

I ran the biondo air on-air off inline linkage stop for years on a terminator. Had very good sucess was consistent and we went rounds every divisional and national we went to. Best advice I got was to go out at least .5 on timer 1 to burn off the extra fuel from being up on the 2 step before going on the stop. Used to run 2500 stop rpm so you basically shut it all the way down so it will bypass fuel properly.

I use the Biondo in-line co2 one as well. Works great! I come on the stop at .08 and was very consistant but after doing more research, I should be waiting between 0.5-0.8 before getting on the stop. Still learning! Good luck with your choice

Awesome,thanks for the input! Were you guys running a 727 or glide with those increments? Thanks again

GLIDE

Glide