Moparts

Charcoal Canister - How to Replace foam pad

Posted By: C_B5

Charcoal Canister - How to Replace foam pad - 09/04/11 01:16 PM

What is the procedure to disassemble the charcoal canister to replace the foam element?

Did not see it in the factory manual, if anyone has the pages showing details please post. This is for a 1972 model though believe they are all the same

Attached picture 6809992-charcoalcan1.jpg
Posted By: burdar

Re: Charcoal Canister - How to Replace foam pad - 09/06/11 06:04 PM

I don't think it comes apart. All you can do is replace the fiberglass filter at the bottom.
Posted By: Moparlar

Re: Charcoal Canister - How to Replace foam pad - 09/06/11 09:03 PM

I believe the filter just tucks under that crossbar on the bottom.

Larry
Posted By: burdar

Re: Charcoal Canister - How to Replace foam pad - 09/06/11 09:05 PM

Yes, the filter just tucks in the bottom but the OP wants to take the whole thing apart and replace the charcole inside. I don't think it comes apart like that.
Posted By: road

Re: Charcoal Canister - How to Replace foam pad - 09/06/11 11:24 PM

I had and extra one and tried to figure out how to take it apart. It was glued together and ended up in quite a few pieces.
Posted By: In_The_Pink

Re: Charcoal Canister - How to Replace foam pad - 09/07/11 01:58 AM

Does the grille twist off?

It's listed in the "Lubrication and Maintenance" section of my '77 van FSM, but the later cannister appears to be a different design:

Attached picture 6814281-ccfilter.jpg
Posted By: burdar

Re: Charcoal Canister - How to Replace foam pad - 09/07/11 03:26 AM

I think the bottom of the early style canisters unscrewed originally. It looks like they were glued in though. Not to mension the years of heat cycles has warped the plastic somewhat.
© 2024 Moparts Forums