Posted By: jsully
Location of fuel vapor line / bulkhead in trunk - 05/12/11 05:11 PM
Can someone please post a picture with dimensions showing where the holes for the fuel vapor lines (holes for bulkhead) are located on a 70 Challenger trunk floor? It has a vent line on top of the fuel filler (just inside fender).
I replaced the trunk floor and extensions and did not 'see' any bulkhead when disassembling.
Thank you
Posted By: cataclysm80
Re: Location of fuel vapor line / bulkhead in trunk - 05/15/11 05:18 AM
Here's a thread I had back in 2008 asking basicaly the same questions. I think you'll find it quite helpfull.
https://board.moparts.org/ubbthreads/show...&PHPSESSID=Note the photo by B5TA shows which one of the two grommets is used, and that the other unused grommet does not have a hole punched in it yet. This is correct. The unpunched grommet is 70 challenger only I believe. Reproductions all come pre-punched.
Tav
Posted By: jsully
Re: Location of fuel vapor line / bulkhead in trunk - 05/15/11 07:58 PM
This is Perfect, Thank you very much.
I am headed out to cut the hole...